Filter
Top Products
HUAWEI VP9050 Executive Video Terminal
User Guide
3 Network Settings
Issue 03 (2011-12-10) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
17
Parameter Description
E1.64
This specifies the site number of a terminal. This number can be
used to call the corresponding terminal if the terminal is registered
with the GK. The site number can contain only digits.
H.323 ID
This specifies the name that is used by the GK to identify a terminal
registered with it.
The name can consist of digits and letters.
Password
This specifies the password used by a terminal to register with the
GK. The GK authenticates the validity of a terminal by checking
this password.
NOTE
For successful GK authentication, the password set on the terminal should be
the same as the preset password on the GK.
Use VoIP gateway
VoIP gateway
address
If Use VoIP gateway is selected, VoIP gateway address must be
set. Then you can place calls to terminals connected to the VoIP
gateway.
Step 2 Save the settings.
----End
3.3.4 Setting SIP Parameters
When the Session Initiation Protocol (SIP) is used for video communications, the SIP
parameters of the terminal, such as whether to register with the SIP server, must be set.
To set the terminal's SIP parameters, do the following:
Step 1 Choose Settings > Network > IP > SIP, and then set the parameters listed in Table 3-5.
Table 3-5 SIP parameters
Parameter Description
Register with server This specifies whether the terminal registers with the SIP server.
Enable: After the terminal is registered with the SIP server
successfully, it can call a remote site using the site number, site
name, or IP address.
Disable:The terminal does not register with the SIP server, and it
can call another site using only the IP address.
Server address This specifies the IP address of the SIP server.