Filter
Top Products
Black plate (53,1)
% Touch AM Step on the initial menu to
select the AM tuning step.
Touching AM Step will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.
Setting the rear output and
subwoofer controller
This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (Full) or subwoofer
(Subwoofer) connection. If you switch the
rear output setting to Subwoofer, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (Full). When rear output is con-
nected to full range speakers (when Full is
selected), you can connect other full range
speakers (Rear) or a subwoofer (Subwoofer)
to the RCA rear output.
! When the multi-channel processor (DEQ-
P7650/DEQ-P6600) is connected to this
unit, you cannot operate this function.
1 Touch Rear Speaker on the initial menu.
2 Touch c or d next to Rear Speaker to
switch the rear output setting.
Touch c to select full-range speaker and Full
appears in the display. Touch d to select sub-
woofer and Subwoofer appears in the dis-
play.
# When no subwooferis connected to the rear
output, select Full(full-range speaker).
# When a subwooferis connected to the rear
output, select Subwoofer(subwoofer).
# When the rear outputsetting is Subwoofer,
you cannot operate thefollowing procedure.
3 Touch c or d next to Preout to switch
the subwoofer output or rear output.
Touching c or d will switch between
Subwoofer and Rear and that status will be
displayed.
Notes
! Even if you change thissetting, there is no
output unless youturn the subwoofer output
on (refer to Usingsubwoofer output on page
46).
! If you change this setting,subwoofer output
in the audio menuwill return to the factory
settings.
! Both rear speaker leadoutputs and RCA rear
output are switched simultaneously in this
setting.
Switching the sound
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
% Touch TEL on the initial menu to select
the setting.
Touch TEL until the desired setting appears in
the display.
! Mute – Muting
! ATT –20dB – Attenuation (ATT –20dB hasa
stronger effect than ATT –10dB)
! ATT –10dB – Attenuation
! Off – Turn the sound muting/attenuation
off
Notes
! The sound is turnedoff,Mute is displayed
and no audio adjustmentsare possible.
! The sound is attenuated,ATT is displayed and
no audio adjustments,except volume control,
are possible.
! Operation returns tonormal when the phone
connection is ended.
<CRB2901-A
/
N>53
Initial Settings
En
53
Section
15
Initial Settings