Filter
Top Products
Black plate (86,1)
3 Turn the ignition switch to ON or ACC.
If the car’s air conditioner or heater is turned
on, turn it off. Noise from the fan in the air
conditioner or heater may prevent correct auto
TA and EQ.
# Press SRC/OFF to turn thesource on if this
unit is turned off.
4 Select the position for the seat on
which the microphone is placed.
Refer to Using the position selector on page
77.
# If no position isselected before you start auto
TA and EQ, Front-L is selected automatically.
5 Touch the source icon and then touch
Off to turn this unit off.
6 Touch the screen to display the touch
panel keys.
7 Touch AV Menu and then touch
Initial Menu to display the function names.
8 Touch Auto EQ&TA to enter the auto TA
and EQ measurement mode.
9 Plug the microphone into the micro-
phone input jack on the multi-channel pro-
cessor.
For details concerning operation, refer to the
multi-channel processor’s operation manual.
10 Touch Start to start the auto TA and EQ.
11 Get out of the car and close the door
within 10 seconds when the 10-second
count-down starts.
The measurement tone (noise) is outputted
from the speakers, and auto TA and EQ be-
gins.
# When all speakers are connected, auto TA
and EQ is completedin about nine minutes.
# To stop auto TA and EQ,touch Stop.
# To cancel auto TA and EQ onthe way, touch
Back or ESC.
12 When auto TA and EQ is completed,
Complete is displayed.
When correct measurement of car interior
acoustic characteristics is not possible, an
error message is displayed. (Refer to Under-
standing auto TA and EQ error messages on
page 91.)
13 Touch ESC to cancel the auto TA and EQ
mode.
14 Store the microphone carefully in the
glove compartment.
Store the microphone carefully in the glove
compartment or any other safe place. If the
microphone is subjected to direct sunlight for
an extended period, high temperatures may
cause distortion, color change or mal-
function.
<CRB2901-A
/
N>86
Available accessories
En
86
Section
19