Filter
Top Products
Black plate (9,1)
2 Press RESET with a pen tip or other
pointed instrument.
RESET button
Note
After completing connectionsor whenyou want
to erase all memorizedsettings or return the unit
to its initial (factory) settings, switchyour engine
ON or set theignition switch to ACC ON before
pressing RESET.
Feature demo mode
The feature demo automatically starts when
you select the source Off. The demo continues
while the ignition switch is set to ACC or ON.
To cancel the feature demo, press and hold
MUTE. To restart the feature demo, press and
hold MUTE again. Remember that if the fea-
ture demo continues operating when the car
engine is turned off, it may drain battery
power.
Important
The red lead (ACC)of this unit should be con-
nected to a terminalcoupled with ignition switch
on/off operations. If thisis not done, the vehicle
battery may be drained.
Use and care of the remote
control
Installing the battery
Slide the tray on the back of the remote con-
trol out and insert the battery with the plus (+)
and minus (–) poles aligned properly.
! When using for the first time, pull out the
film protruding from the tray.
WARNING
Keep the battery out of the reachof children.
Should the battery be swallowed, consulta doc-
tor immediately.
CAUTION
! Use one CR2025(3V) lithium battery.
! Remove thebattery if the remote control is not
used for a monthor longer.
! There is a dangerof explosion if the battery is
incorrectly replaced. Replace only with the
same or equivalent type.
! Do not handle thebattery with metallic tools.
! Do not store thebattery with metallic objects.
! If the battery leaks, wipe the remotecontrol
completely clean andinstall a new battery.
! When disposing ofused batteries, comply
with governmental regulations or environmen-
tal public institutions’ rules that apply in your
country/area.
Using the remote control
Point the remote control in the direction of the
front panel to operate.
! The remote control may not function prop-
erly in direct sunlight.
Important
! Do not store theremote control in high tem-
peratures or direct sunlight.
! Do not let theremote control fall onto the
floor, where it may become jammedunder the
brake or accelerator pedal.
<CRB2901-A
/
N>9
Before You Start
En
9
Section
02
Before You Start