Filter
Top Products
Black plate (80,1)
4 Touch d to turn the panorama control
on.
# To turn the panorama control off,touch c.
5 Touch b to select Dimension and then
touch c or d to adjust front/rear speaker
balance.
Each time you touch c or d it moves the
sound towards the front or the rear.
+3 to -3 is displayed as the front/rear speaker
balance moves from front to rear.
6 Touch b to select Center Width and
then touch c or d to adjust the center
image.
Each time you touch c or d it gradually
spreads the center channel sound into the
front left and right speakers over a range 0 to
7.
3 is the default and it’s recommended for
most recordings. 0 places all center sound in
the center speaker. 7 places all center sound
equally in the left/right speakers.
Setting the speaker setting
You need to make with/without (or yes/no) and
size (bass reproducing capacity) selection/ad-
justments depending on the installed speak-
ers. The size needs to be set to Large (large) if
the speaker is capable of reproducing sounds
of about 100 Hz or below. Otherwise select
Small (small).
! Low frequency range is not output if the
subwoofer is set to Off and the front and
rear speakers set to Small or Off.
! It is imperative that non-installed speakers
be set to Off.
! Set the front or rear speaker to Large if the
speaker is capable of reproducing bass
content, or if no subwoofer is installed.
1 Touch Speaker Setting.
2 Touch a or b to select the speaker to
be adjusted.
Each time you touch a or b selects the speak-
er in the following order:
Front (front speakers)—Center (center speak-
er)—Rear (rear speakers)—Subwoofer (sub-
woofer)—Phase (subwoofer setting)
# You can switchto Phase only when the sub-
woofer has been setto On.
3 Touch c or d to select the correct size
for the selected speaker.
Each time you touch c or d selects the size in
the following order:
Off (off)—Small (small)—Large (large)
# You cannot selectOff, when Front (front
speakers) have beenselected.
# You can selectOn or Off, when Subwoofer
(subwoofer) has beenselected.
# You can switchReverse (reverse phase) or
Normal (normal phase),when Phase (subwoofer
setting) has been selected.
Correcting the subwoofer’s phase
If trying to boost the bass output of the sub-
woofer doesn’t do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer’s output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Touch Speaker Setting.
2 Touch a or b to select Subwoofer (sub-
woofer).
Each time you touch a or b selects the speak-
er in the following order:
Front (front speakers)—Center (center speak-
er)—Rear (rear speakers)—Subwoofer (sub-
woofer)—Phase (subwoofer setting)
3 Touch d to turn subwoofer output on.
# To turn subwoofer output off, touchc.
4 Touch b and then touch c or d to se-
lect the phase of subwoofer output.
Touch d to select normal phase and Normal
appears in the display. Touch c to select re-
verse phase and Reverse appears in the dis-
play.
<
CRB2901-A
/
N>80
Available accessories
En
80
Section
19