Filter
Top Products
Black plate (81,1)
Note
When playing a 2-channelmono source with
Dolby Pro Logic II turnedon, there may be occa-
sions when the followingwill occur:
! No audio is outputted if the center speaker
setting is Small orLarge and no center speak-
er is installed.
! Audio is heard onlyover the center speaker if
installed and the centerspeaker setting is
Small or Large.
Adjusting the speaker output
levels
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.
1 Touch Speaker Level.
2 Touch a or b to select the speaker to
be adjusted.
Each time you touch a or b selects the speak-
er in the following order:
Front-L (front speaker left)—Center (center
speaker)—Front-R (front speaker right)—
Rear-R (rear speaker right)—Rear-L (rear
speaker left)—Subwoofer (subwoofer)
# You cannot selectspeakers whose size is set
to Off. (Refer toSetting the speaker setting on the
previous page.)
3 Touch c or d to adjust the speaker out-
put level.
Each time you touch c or d it increases or de-
creases the equalizer level. +10 to –10 is dis-
played as the level is increased or decreased.
Note
To adjust the speaker output levelsin this mode is
the same as makingthe speaker output levels at
Test Tone. Bothprovide the same results.
Selecting a cross-over frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to Small, you can select a
frequency, under which sounds are repro-
duced through a Large speaker or subwoofer.
1 Touch Cross Over.
2 Touch a or b to select the speaker to
be adjusted.
Each time you touch a or b selects the speak-
er in the following order:
Front (front speakers)—Center (center speak-
er)—Rear (rear speakers)—Subwoofer (sub-
woofer)
3 Touch c or d to select cross-over fre-
quency.
Each time you touch c or d selects cross-over
frequencies in the following order:
63Hz—80Hz—100Hz—125Hz—160Hz—
200Hz
Note
Selecting a cross-over frequency is to seta cross-
over frequency of the subwoofer’s L.P.F.(low-pass
filter) and that of theSmall speaker H.P.F. (high-
pass filter). The cross-over frequency settinghas
no effect if the subwooferis set to Off andother
speakers are set toLarge or Off.
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1 Touch Test Tone.
<
CRB2901-A
/
N>81
Available accessories
En
81
Section
19
Available accessories