Filter
Top Products
Black plate (76,1)
Storing the strongest broadcast
stations sequentially
% Touch BSSM on the function menu to
turn BSSM on.
BSSM begins to flash. While BSSM is flashing
the 12 strongest broadcast stations will be
stored in order from the lowest channel up.
When finished, BSSM stops flashing.
# To cancel the storage process,touch BSSM
again.
Note
Storing broadcast stationswith BSSM may re-
place broadcast stationsyou have saved using
P01 to P12.
Selecting the area group
1 Touch Country on the function menu.
2 Touch c or d to select the area group.
Touch c or d until the desired area group ap-
pears in the display.
Country 1 (CCIR channel) —Country 2 (IN
channel)—Country 3 (CHN channel)—
Country 4 (U.K. channel) —Country 5 (OIRT
channel)—Country 6 (AUSTRALIA channel)
—Country 7 (SAF channel)
Digital Signal Processor
Introduction of DSP adjustm ents
1
You can use this unit to control multi-channel
processor (DEQ-P7650/DEQ-P6600), which is
sold separately.
1 DSPdisplay
Shows the DSP function names.
By carrying out the following settings/adjust-
ments in the order shown, you can create a fi-
nely-tuned sound field effortlessly.
1 Setting the speaker setting
2 Using the position selector
3 Auto TA and EQ (auto-time alignment andauto-
equalizing)
4 Adjusting the time alignment
5 Adjusting the speaker output levelsusing a
test tone
6 Selecting a cross-over frequency
7 Adjusting the speaker output levels
8 Adjusting 3-band parametricequalizer
1 Touch AV Menu and then touch
DSP Menu to display the DSP function
names.
The DSP function names are displayed and
operable ones are highlighted.
# To go to the next groupof function names,
touch b.
# To return to the previous groupof function
names, touch a.
# When playing discsrecorded with more than
96 kHz sampling frequency, you cannot use audio
functions. Also,equalizer curve setting, Position,
Auto EQ and AutoTA will be canceled.
<CRB2901-A
/
N>76
Available accessories
En
76
Section
19