Open as PDF
Playing songs on iPod
You can control and listen to songs on an
! For details about the supported iPod, refer
to iPod compatibility on page 72.
! When using an iPod, iPod Dock Connector
to USB Cable is required.
1 Song number indicator
2 iPod name
3 Voltage indicator
Shows the battery voltage.
! The level displayed on the voltage indi-
cator may differ from the actual voltage
4 Play time indicator
5 Song time (progress bar)
% Connecting an iPod
1 Plug an iPod into theUSB port using the
iPod Dock Connector toUSB Cable.
Regarding the position of USB port, refer to
Head unit onpage 10.
2 Press SRC/Off to select iPod as a source.
Playback will start.
% Fast forward or reverse
Push and hold MULTI-CONTROL left or right.
% Select a track (chapter)
Push MULTI-CONTROL left or right.
% Disconnecting an iPod
Pull out the iPod Dock Connector to USB
! Read the precautions foriPod in the following
section. Refer to page 72.
! If an errormessage is displayed, refer to Error
messages on page 68.
! When the ignition switch is set to ACC orON,
the iPod’s battery is charged while the iPod is
connected to this unit.
! While the iPod is connected to this unit, the
iPod cannot be turnedon or off. However
when the control mode is set to iPod, you can
turn the iPod on or off.
! Before connecting the iPod to this unit, dis-
connect the headphones fromthe iPod.
! The iPod is turned off abouttwo minutes after
the ignition switch is set to OFF.
Browsing for a song
Operations to control an iPod with this unit is
designed to be as close to the iPod as possible
to make operation and song search easy.
! Depending on the number of files in the
iPod, there may be a delay when displaying
! If the characters recorded on the iPod are
not compatible with this unit, those charac-
ters are not displayed.
Searching songs by category
% Use MULTI-CONTROL to select a song.
Turn to change the category. Press to select.
Playlists (playlists)—Artists (artists)—
Albums (albums)—Songs (songs)—Podcasts
List for the selected category is displayed.
# You can start playback throughout the se-
lected category by pressing and holding
MULTI-CONTROL. You can also perform this op-
eration by pushing and holding
# You can also change thecategory by pushing
MULTI-CONTROL up or down.
# You can also select thecategory bypushing
# To return to the previous category, push
MULTI-CONTROL lef t.
# To return to the top tier of categories, push
and hold MULTI-CONTROL left.
Operating this unit