Filter
Top Products
3 Press MULTI-CONTROL to turn the se-
lected speaker on.
# To turn off, press MULTI-CONTROL again.
Setting the clock
Use these instructions to set the clock.
1 Use MULTI-CONTROL to select Clock in
the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Push MULTI-CONTROL left or right to
select the segment of the clock display you
wish to set.
Pushing MULTI-CONTROL left or right will se-
lect one segment of the clock display:
Hour—Minute
As you select segments of the clock display,
the selected segment blinks.
3 Push MULTI-CONTROL up or down to
put a clock right.
# You can match the clockto a time signal by
pressing MULTI-CONTROL.
! If 00 to 29, the minutes are rounded down.
(e.g., 10:18 becomes 10:00.)
! If 30 to 59, the minutes are rounded up.
(e.g., 10:36 becomes 11:00.)
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1 Use MULTI-CONTROL to select
Warning tone in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to turn warning
tone on.
# To turn warningtone off, press
MULTI-CONTROL again.
Switching the face auto open
To protect against theft, this unit features de-
tachable front panel. To detach the front panel
easily, the front panel opens automatically.
This function is on as a default.
1 Use MULTI-CONTROL to select
Face auto open in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to turn the face
auto open on.
# To turn the face auto open off, press
MULTI-CONTROL again.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source on page 41.
1 Use MULTI-CONTROL to select AUX1/
AUX2 in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to turn AUX1/
AUX2 on.
# To turn AUXoff, press MULTI-CONTROL
again.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car’s headlights are turned on. You
can turn the dimmer on or off.
1 Use MULTI-CONTROL to select Dimmer
in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
Initial Settings
En
36
Section
04