Filter
Top Products
8 Press MULTI-CONTROL to select a posi-
tion.
Each press of MULTI-CONTROL selects set-
tings in the following order:
Front left (front left)—Front right (front right)
Select the position for the seat on which the
microphone is placed.
9 Turn MULTI-CONTROL to select
Select N/W mode in the auto TA and EQ
menu.
10 Press MULTI-CONTROL to select a net-
work mode.
Each press of MULTI-CONTROL selects set-
tings in the following order:
Auto N/W (auto)—Custom N/W (custom)
# If you want to carry outauto TA and EQ based
on previously customized networksettings, select
Custom N/W. Otherwise, select Auto N/W.
# If manually adjusted value is not suitable for
the actual specifications of the speakers, auto-
time alignment and auto-equalizer may not per-
form properly.
11 Turn MULTI-CONTROL to select
Auto TA & EQ stop in the auto TA and EQ
menu.
12 Press MULTI-CONTROL to start the auto
TA and EQ.
13 Get out of the car and close the door
within 10 seconds when the 10-second
count-down starts.
The measurement tone (noise) is outputted
from the speakers, and auto TA and EQ be-
gins.
# To stop auto TA andEQ, press
MULTI-CONTROL again.
# To cancel autoTA and EQ part way through,
press B.
14 When auto TA and EQ is completed,
Complete is displayed.
When correct measurement of car interior
acoustic characteristics is not possible, an
error message is displayed. (Refer to Under-
standing auto TA and EQ error messages on
page 69.)
15 Press B to cancel the auto TA and EQ
mode.
16 Store the microphone carefully in the
glove compartment.
Store the microphone carefully in the glove
compartment or any other safe place. If the
microphone is subjected to direct sunlight for
an extended period, high temperatures may
cause distortion, color change or malfunction.
Note
Make sure you have disconnected the micro-
phone before pressing h/Open to open or close
the panel (an alert sounds if the micis still con-
nected).
Audio Adjustments
En
34
Section
03