Filter
Top Products
Turning On & Basic Operations
En-26
When a new version of the firmware is available, the
notification window “AV receiver : Firmware Update
Available” pops up. This notification only appears
when the AV receiver is connected to the Internet
(➔ pages 20, 31). To perform the firmware update,
follow the instructions on screen.
Use / and ENTER on the AV receiver or remote
controller to select one of the options.
`Update Now:
Starts the firmware update.
Refer to “Firmware Update” (➔ page 104).
`Remind me Later:
The update notification will pop up again the
next time you turn the AV receiver on.
`Never Remind me:
Disables the automatic update notification.
Tip
• The update notification window can be enabled or disabled
in “Update Notice” (➔ page 81).
By way of optimized circuitry, this function reduces
power consumption when the AV receiver is in
standby mode. The HYBRID STANDBY indicator will
light in either of the following conditions:
–“HDMI Through” is enabled (the HDMI indicator is
off).
–“Network Standby” is enabled (the NET indicator
is off).
Note
• If Zones are turned on or, if a mobile device connected to
the Front Input (MHL) is charging, the HYBRID STANDBY
indicator won’t light.
Initial Setup
This section explains the settings that we recommend
you to make before using the AV receiver for the very
first time. A setup wizard is launched upon first-time
use to let you perform those settings.
Tip
• The on-screen menus appear only on a TV that is
connected to HDMI OUT MAIN.
This step determines the language used for the on-
screen setup menus. See “Language” in “OSD
Setup” (➔ page 77).
Tip
• Pressing HOME will close the setup wizard. To restart the
initial setup, select “Initial Setup” in the “Hardware Setup”
menu (➔ page 81).
After selecting the language for on-screen setup
menus, a welcome screen is displayed.
This step performs the automatic speaker setup.
Firmware Update Notification
About the HYBRID STANDBY indicator
Selecting the Language for the On-
screen Setup Menus
1st Step : Audyssey MultEQ XT32: Auto Setup
2nd Step : Source Connection
3rd Step : Remote Mode Setup
4th Step : Network Connection
Yes
No
Welcome to initial setup. Have you connected all the speakers and devices?
Before starting, please connect speakers and sources.
Now, would you like to start initial setup?
Exit
Initial Setup
HOME
1
Use / on the AV receiver or remote
controller to select one of the following
options, and then press ENTER.
`Yes:
Continues to “Audyssey MultEQ XT32:
Auto Setup”.
`No:
Skips the settings and terminates the initial
setup. The setup wizard goes to
“Terminating the Initial Setup” (➔ page 27).
You can always restart the initial setup by
selecting “Initial Setup” in the “Hardware
Setup” menu (➔ page 81).
Audyssey MultEQ XT32: Auto Setup
1
Use / to select one of the following options,
and then press ENTER.
`Do it Now:
The automatic speaker setup is performed
following instructions on screen. Refer to
step 2 of “Using the Automatic Speaker
Setup” (➔ page 28). When this setting is
complete, the setup wizard continues to
“Source Connection”.
`Do it Later:
Skips this setting.
Press ENTER and continue to “Source
Connection”.