Filter
Top Products
Advanced Operations
En-82
Operating
procedure
(➔ page 61)
Remote ID
■ Remote ID
`1
, 2, or 3
When several Onkyo components are used in the
same room, their remote ID codes may overlap. To
differentiate the AV receiver from other components,
you can change its remote ID from “1”, to “2” or “3”.
Note
• If you do change the AV receiver’s remote ID, be sure to
change the remote controller to the same ID (see below),
otherwise, you won’t be able to control it with the remote
controller.
Changing the remote controller’s ID
Remote Mode Setup
See “Looking up for Remote Control Codes”
(➔ page 87).
With this preference, you can protect your settings by
locking the setup menus.
■ Setup
`Locked
`Unlocked
When “Locked” is selected, the setup menus will be
locked and you cannot change any setting.
8. Remote Controller Setup
1
While holding down RECEIVER, press and
hold down Q SETUP until the RECEIVER lights
(about 3 seconds).
2
Use the number buttons to enter ID 1, 2, or 3.
RECEIVER flashes twice.
9. Lock Setup