Filter
Top Products
Advanced Operations
En-58
Operating
procedure
(➔ page 57)
Note
*1
“BLUETOOTH” cannot be selected, if you’ve selected
NET or USB as input selector in Multi Zone.
*2
When HDMI IN 1/2/3/AUX INPUT is displayed on the
main preview, HDMI IN 4 is also displayed on the
preview thumbnails.
*3
• The video preview is not displayed when the “Zone 2
Monitor Out” setting is set to “Use” (➔ page 62).
• The video of the currently-selected input is displayed on
the main screen, not on a preview thumbnail.
*4
“Dynamic EQ” and “Dynamic Volume” cannot be
selected when any of the THX listening modes is
selected, with “Loudness Plus” set to “On” or “Preserve
THX Settings” set to “Yes” (➔ pages 67, 68).
*5
• When the “Monitor Out” setting is set to “Sub”, “Video”
cannot be selected (➔ page 62).
• This setting cannot be used with the “NET”, “USB” and
“BLUETOOTH” input selectors.
*6
Only when you have selected “Custom” in the “Picture
Mode” (➔ page 74), pressing ENTER allows you to
adjust the following items via the Quick Setup:
“Brightness”, “Contrast”, “Hue” and “Saturation”. Press
RETURN to return to the “Picture Mode” setting.
*7
Depending on the input source and listening mode, not
all channels shown here output the sound.
*8
• This setting is not available in either of the following
cases:
– The “Audio TV Out (Main)” setting is set to “On”
(➔ page 79) or “Audio TV Out (Sub)” setting is set to
“On” (➔ page 79) and you’re listening through your TV
speakers.
–“HDMI CEC (RIHD)” is set to “On” (➔ page 78) and
you’re listening through your TV speakers.
Explanatory Notes
Setting target
Setting options (default setting underlined)
You can change various audio settings from the
Quick Setup (➔ page 57).
Note
• These settings are not available in either of the following
cases:
–The “Audio TV Out (Main)” setting is set to “On”
(➔ page 79) or “Audio TV Out (Sub)” setting is set to
“On” (➔ page 79) and you’re listening through your TV
speakers.
–“HDMI CEC (RIHD)” is set to “On” (➔ page 78) and
you’re listening through your TV speakers.
Sound Program
■ Sound Program
`Stereo Source 1, Stereo Source 2, Stereo
Source 3, Multich Source 1, Multich Source 2,
Multich Source 3
`Off
With this setting, you can select the combination of
settings that you registered in “Sound Program Edit”
(➔ page 71).
Note
• If the input selector is changed, the “Sound Program”
setting is switched back to “Off”.
Tone Control
■ Bass
`–10dB to 0dB
to +10dB in 2 dB steps.
You can boost or cut low-frequency sounds
output from the front speakers.
■ Treble
`–10dB to 0dB
to +10dB in 2 dB steps.
You can boost or cut high-frequency sounds
output from the front speakers.
You can adjust the bass and treble for the front
speakers, except when the Direct, Pure Audio or THX
listening mode is selected.
Operating on the AV receiver
■ Phase Matching Bass
`Off
`On
Using the Audio Settings of Quick
Setup
1
Press TONE repeatedly to select either “Bass”
or “Treble”.
2
Use – and + to adjust.