Filter
Top Products
Turning On & Basic Operations
En-29
1
Turn on the AV receiver and the connected TV.
On the TV, select the input to which the AV
receiver is connected.
2
Set the speaker setup microphone at the Main
Listening Position , and connect it to the
SETUP MIC jack.
The speaker setting menu appears.
Note
• The on-screen menus appear only on a TV that is
connected to HDMI OUT MAIN. If your TV is
connected to other video outputs, use the AV
receiver’s display when changing settings.
3
When you’ve finished making the settings,
press ENTER.
Perform the “2. Speaker Setup” according to your
speaker configuration:
–Speakers Type(Front) (➔ page 65)
–Powered Zone 2 (➔ page 65)
–Powered Zone 3 (➔ page 65)
–11ch Playback (➔ page 65)
–Subwoofer (➔ page 65)
If you use a powered subwoofer(s), go to step 4.
If not, go to step 5.
Speaker setup microphone
SETUP MIC jack
MultEQ XT32: Auto Setup
AUDYSSEY
Speakers Type(Front)
Powered Zone 2
Powered Zone 3
11ch Playback
Subwoofer
Normal
No
No
No
Yes
If “Speakers Type(Front)” is set to “Digital
Crossover”, a confirmation screen appears.
Select “Next” to display the screen for Digital
Processing Crossover Network (➔ page 68).
Continue with the settings.
4
Adjust the subwoofer volume level to 75 dB,
and then press ENTER.
Test tones are played through the subwoofer.
Use the volume control on the subwoofer.
Note
• If your subwoofer does not have a volume control,
disregard the displayed level and press ENTER to
proceed to the next step.
• If you set the subwoofer’s volume control to its
maximum and the level displayed is lower than 75 dB,
leave the subwoofer’s volume control at its maximum
and press ENTER to proceed to the next step.
5
Use / to select “Audyssey Quick Start” or
“Audyssey MultEQ XT32 Full Calibration”,
and then press ENTER.
6
Press ENTER.
Audyssey MultEQ
®
XT32 Room Correction and
Speaker Setup starts.
Test tones are played through each speaker as
Audyssey MultEQ XT32 Room Correction and
Speaker Setup runs. This process takes a few
minutes. Please refrain from talking during
measurements and do not stand between
speakers and the microphone.
Do not disconnect the speaker setup microphone
during Audyssey MultEQ XT32 Room Correction
and Speaker Setup, unless you want to cancel
the setup.
If you select “Audyssey Quick Start”, you will go
to step 9.
7
Place the speaker setup microphone at the
next position, and then press ENTER.
Audyssey MultEQ XT32 performs more
measurements. This takes a few minutes.
8
When prompted, repeat step 7.
9
Use / to select an option, and then press
ENTER.
The options are:
`Save:
Save the calculated settings and exit
Audyssey MultEQ XT32 Room Correction
and Speaker Setup.
`Cancel:
Cancel Audyssey MultEQ XT32 Room
Correction and Speaker Setup.
Tip
• You can view the calculated settings for the speaker
configuration, speaker distances, and speaker levels
by using / .
Save
Cancel
AUDYSSEY
MultEQ XT32: Auto Setup
-- Review Speaker Configuration --
Subwoofer
Front
Center
Surround
Front Wide
Front High
Surround Back
Surround Back Ch
Yes
100Hz
40Hz
100Hz
None
100Hz
120Hz
2ch