Filter
Top Products
Controlling Other Components
En-94
The AV receiver’s remote controller can learn the
commands of other remote controllers. By
transmitting, for example, the Play command from
your CD player’s remote controller, the supplied
remote controller can learn it and then reproduce the
exact same command when its is pressed in CD
remote mode.
This is useful when some buttons don’t work as
expected though you entered the appropriate remote
control code (➔ page 87).
Note
• The following buttons cannot learn new commands:
RECEIVER, ALL OFF, MY MOVIE, MY TV, MY MUSIC,
REMOTE MODE, MODE.
• The remote controller can learn approximately 70 to 90
commands, although this will be less if commands that use
a lot of memory are learned.
• Remote controller buttons such as Play, Stop, and Pause
are preprogrammed with commands for controlling Onkyo
CD players, cassette decks, and DVD players. However,
they can learn new commands, and you can restore the
preprogrammed commands at any time by resetting the
remote controller (➔ page 89).
• To overwrite a previously acquired command, repeat this
procedure.
• Depending on the remote controller used, some buttons
may not respond as expected, or the learning process itself
may not be possible.
• Only commands from infrared remote controllers can be
acquired.
• When the remote controller runs out of batteries, all
commands acquired will be lost and will have to be learned
all over again. Therefore, do not discard your other remote
controllers.
■ Deleting Acquired Commands
1. While holding down the REMOTE MODE button
for the mode from which you want to delete a
command, press and hold down TV until the
REMOTE MODE button lights (about 3 seconds).
2. Press the REMOTE MODE button or the button
from which you want to delete the command.
The REMOTE MODE button flashes twice.
When you press the REMOTE MODE button, all
commands learned in that mode will be deleted.
Learning Commands
1
While holding down the REMOTE MODE
button for the mode in which you want to use
the command, press and hold down
RECEIVER until the REMOTE MODE button
lights (about 3 seconds).
2
On the supplied remote controller, press the
button to which you want to assign the new
command.
3
Point the remote controllers at each other,
within about 4 inches (10 cm) apart, and then
press and hold the button whose command
you want to acquire until the REMOTE MODE
button flashes.
RECEIVER
REMOTE
MODE
If the command is learned successfully, the
REMOTE MODE button flashes twice.
4
To learn more commands, repeat steps 2 and
3.
Press any REMOTE MODE button when
you’ve finished. The REMOTE MODE button
flashes twice.
Within about
4 inches (10 cm)
Supplied remote
controller