Filter
Top Products
Advanced Operations
En-62
Operating
procedure
(➔ page 61)
Explanatory Notes
Main Menu
Sub Menu
Setting target
Setting options (default setting underlined)
Monitor Out
On the “Monitor Out” settings, you can select
whether or not to have the video sources’ images
output through the HDMI output.
If you connect your TV to HDMI output, “Monitor Out”
setting is automatically set and composite video and
component video sources are upconverted
*
and
output.
Note
• See “The video and audio signal flow” (➔ page 21) for
charts showing how the “Monitor Out” and “Resolution”
settings affect the video signal flow through the AV
receiver.
■ Monitor Out
`Main
:
Select this if your TV is connected to HDMI OUT
MAIN.
`Sub:
Select this if your TV is connected to HDMI OUT
SUB.
`Both:
Select this if your TVs are connected to HDMI
OUT MAIN and HDMI OUT SUB. Video signals
are output from both HDMI outputs at the
resolution supported by both TVs.
Note
• The “HDMI Through” setting is only available for the HDMI
OUT MAIN jack (➔ page 78).
Operating on the AV receiver
■ Zone 2 Monitor Out
`Not Use
`Use
When this setting is enabled, the TV connected to
HDMI OUT ZONE 2 can be used as the TV of Zone 2.
Tip
• On the connected component, select the mode in which the
delay between the video and audio does not occur much if
the video signal delay occurs during the playback on the
video component connected to the AV receiver.
Note
• This setting cannot be selected if the “Monitor Out” setting
is set to “Sub” or “Both”.
• When this setting is set to “Use”, the “11ch Playback”
setting is fixed to “No” (➔ page 65).
• When this setting is set to “Use” and “GAME2” is selected
as the input source for Zone 2, if this setting is changed to
“Not Use”, the input source for Zone 2 will be changed to
“Zone 2 Selector: Source” (➔ page 84).
Speaker Configuration
■ Subwoofer
`Yes
`No
2. Speaker Setup
Main Menu
Sub Menu
1. Input/Output Assign
IN
OUT
Composite video,
component video
HDMI
HDMI
Composite video,
component video
1
Press MONITOR OUT on the front panel.
The current setting is displayed.
2
Press MONITOR OUT on the AV receiver
repeatedly to select:
`Main, Sub or Both.