Filter
Top Products
Advanced Operations
En-69
Operating
procedure
(➔ page 61)
Tip
• Sounds processed by Digital Processing Crossover
Network are played.
• You can switch from the current audio source to test noises
by pressing MODE/D (Blue).
■ High Distance, Low Distance
`0inch(0.0cm)
to 12inch(30.0cm) in 1 inch
(2.5 cm) steps.
With this setting, you can adjust the virtual position of
tweeter and woofer units. Adjusting “High Distance”
virtually shifts woofers behind tweeters. Adjusting
“Low Distance” virtually shifts tweeters behind
woofers.
Tip
• Sounds processed by Digital Processing Crossover
Network are played.
• You can switch from the current audio source to test noises
by pressing MODE/D (Blue).
With the Audio Adjust functions and settings, you can
adjust the sound and listening modes as you like.
Multiplex/Mono
■ Multiplex
Input Channel
`Main
`Sub
`Main/Sub
This setting determines which channel of a stereo
multiplex source is output. Use it to select audio
channels or languages with multiplex sources,
multilingual TV broadcasts, and so on.
■ Mono
Input Channel
`Left + Right
`Left
`Right
This setting specifies the channel to be used for
playing any 2-channel digital source such as Dolby
Digital, or 2-channel analog/PCM source in the Mono
listening mode.
Output Speaker
`Center
:
Mono audio is output by the center speaker.
`Left / Right:
Mono audio is output by the front left and right
speakers.
This setting determines which speakers output mono
audio when the Mono listening mode is selected.
Note
• If the “Center” setting is set to “None” (➔ page 65), this
setting cannot be selected.
Dolby
■ PL IIx Music (2ch Input)
These settings apply to only 2-channel stereo
sources.
If you’re not using any surround back speakers, these
settings apply to Dolby Pro Logic II, not Dolby Pro
Logic IIx.
Panorama
`On
`Off
With this setting, you can broaden the width of the
front stereo image when using the Dolby Pro Logic IIx
Music listening mode.
Dimension
`–3 to 0
to +3
With this setting, you can move the sound field
forward or backward when using the Dolby Pro Logic
IIx Music listening mode. Higher settings move the
sound field backward. Lower settings move it forward.
If the stereo image feels too wide, or there’s too much
surround sound, move the sound field forward to
improve the balance. Conversely, if the stereo image
feels like it’s in mono, or there’s not enough surround
sound, move it backward.
Center Width
`0 to 3
to 7
With this setting, you can adjust the width of the
sound from the center speaker when using the Dolby
Pro Logic IIx Music listening mode. Normally, if you’re
using a center speaker, the center channel sound is
output from only the center speaker. (If you’re not
using a center speaker, the center channel sound will
be distributed to the front left and right speakers to
create a phantom center.) This setting controls the
front left, right, and center mix, allowing you to adjust
the weight of the center channel sound.
(Low Distance)
Tweeter
Woofer
(High Distance)
Distance Distance
3. Audio Adjust