Filter
Top Products
RV-5 Appendix C
C-5
1. Line up the RV-5 remote control with the other remote control,
head-to-head, one or two inches apart.
2. On the RV-5 remote control, press and hold the MAIN and ENT
(Enter) buttons at the same time. After about 3 seconds, “SETUP”
is displayed in the Menu name area at the top of the LCD touch
screen. This is the Setup mode of the remote control.
NOTE: You now have 30 seconds to perform the next step while the
remote is in the Setup mode. If a button is not pressed within 30
seconds, the SETUP menu name will revert to MAIN, indicating that
the remote control is no longer in Setup mode. If this occurs, you will
need to repeat this step to re-enter the Setup mode.
3. Touch the LEARN option to select the Button Learning Method.
The menu name changes to “LEARN” and the menu options area
now contains seven component options. The bottom of the
screen flashes “SELECT”.
4. Select the component that you want to program. If the
component you wish to setup is not on this page, touch the menu
page arrow to select from the components on page 2.
Once a selection is made, the menu name changes to the
selected component name.
If you want to teach any command to a component button on
the RV-5 remote control, press the component button when
the menu name says “LEARN”. The menu name will change to
“READY” and the menu page area indicates the button that you
pressed. If you pressed the wrong button, press the MAIN
button to return to the Setup menu where you can start again
(return to Step 3). Once “READY” is displayed, skip ahead to
Step 6.
5. Select the component option that you want to teach the
command to - everything except for the MAIN button and the
menu page arrows can be taught. The menu name will change
to “READY” and the menu page area indicates the button that
you pressed.
6. Press and hold the button on the other remote control that you
want to teach to the RV-5 remote. When the menu name on the
touch screen of the RV-5 remote control changes to “GOOD” or
“FAILD”, release the button.
If “GOOD” is displayed, the bottom of the screen flashes
“SAVED”. The learning procedure is complete and was
successful.
If “FAILD” is displayed, try teaching the same button once
again by repeating Steps 5 & 6.
7. Repeat Steps 4 through 6 to teach the RV-5 remote control any
additional button commands from the component’s remote. To
return to Step 4, press the MAIN button once.
8. When you are done teaching the Lexicon remote control, exit the
Setup mode by pressing the MAIN button until the touch screen
displays MAIN in the menu heading area. The remote control is in
normal operation mode again.
Test all your new commands. If any of them don’t work, try the button
learning procedure again, keeping in mind the following suggestions:
• Move to another room. Plasma TVs, sunlight, halogen, or
quartz lighting can interfere with the learning process.
• Even though the old remote seems to be working fine,
replace the current batteries with fresh alkaline batteries.
• Gradually vary the distance between the remote controls.
Try 1-inch, 2-inches, and so on up to 4-feet.
• Try tapping the button on your old remote instead of just
pressing and holding it during the learning process.
The following list provides additional information regarding the button
learning procedure and how the RV-5 remote control behaves when
taught.