Filter
Top Products
RV-5 Setup
3-3
DISPLAY SETUP
Selecting the SETUP menu DISPLAY SETUP option opens the DISPLAY SETUP menu, which is used to customize the OSD and front panel display,
and setup other display-related features.
CONNECTION ANALOG, HDMI/DVI
Selects the CONNECTION parameter, which identifies the active
video output connectors on the RV-5 rear panel. The following list of
conditions identify the behavior of this parameter.
• If ANALOG is selected, only the analog video connectors are
available and will output the video signal.
• If HDMI/DVI is selected, both the analog and HDMI video
connectors are available and will output the video signal.
• If the video input is set to HDMI and the CONNECTION
parameter is set to ANALOG, then no video is output.
• If the HDMI video input is copy-protected (HDCP), no video is
output on the analog output connectors. This is a requirement
of HDCP and not a limitation of the RV-5 Receiver.
HDMI AUDIO OUT YES, NO
Selects the HDMI AUDIO OUT parameter, which identifies if audio is
sent on the HDMI output. If the HDMI AUDIO OUT parameter is set
to YES, then a two-channel DOWN MIX of the source audio is sent
over the HDMI connection at the maximum bit rate of the display’s
audio system. This audio stream is in addition to the normal audio
outputs. If the parameter is set to NO, this audio is not sent.
2-LINE OSD OFF, 3, 4, 5, 6 SECONDS
Selects the 2-LINE OSD parameter from the On-Screen Display (OSD)
menu. The 2-Line OSD parameter identifies the length of time that
the 2-line OSD is displayed and can be set to display from three to six
seconds in one-second increments. If OFF is selected, then the 2-line
OSD is not displayed.
Note: If OFF is selected, the menu screens are still displayed. This
parameter only affects the 2-line OSD display, which is identical to the
front panel 2-line display.
ON-SCREEN DISPLAY
2-LINE OSD: 3s
MENU TIME OUT: 30s
FRONT PANEL DISPLAY
BRIGHTNESS: FULL
TIME OUT: NONE
MAIN MENU
AUDIO CONTROLS
VIDEO CONTROLS
DISPLAY SETUP
SPEAKER/EQ SETUP
INPUT SETUP
SURROUND CONFIG
DOLBY CONFIG
MUTE LEVELS
POWER ON SETTINGS
SETUP
SETUP
DISPLAY SETUP
CONNECTION: HDMI/DVI
HDMI AUDIO OUT: NO
ON-SCREEN DISPLAY
FRONT PANEL DISPLAY
DISPLAY SETUP
SETUP
CONNECTION
DISPLAY SETUPSETUP
HDMI AUDIO OUT
DISPLAY SETUPSETUP
ON-SCREEN DISPLAY 2-LINE OSD