Filter
Top Products
Basic Operation Lexicon
2-4
pressing a Zone 2 input selection button activates the
corresponding input in Zone 2.
When the RV-5 is in Standby, pressing a Zone 2 input selection
button powers on the RV-5, selects the input in Zone 2, and turns
off the Main Zone.
7 ZONE 2 OFF BUTTON
Deactivates Zone 2. When Zone 2 is off, the Zone 2 OFF button on
the front panel lights red.
8 MAIN ZONE OFF BUTTON
Deactivates the Main Zone. When the Main Zone is off, the Main
Zone OFF button on the front panel lights red.
Note: Activating the Main Zone OFF button on the front panel turns off
the audio, however the video continues to be output through both the
analog and HDMI video outs. If using the HDMI Video In connection, only
the HDMI video is output. If the analog Video In is used, then both analog
and HDMI video is output. Main Zone OSD (On-Screen Display) menus
are also still available.
9 MUTE BUTTON
Mutes the Main Zone and Zone 2 volumes. Press the MUTE button to
mute the Main Zone volume level; “MUTE ON” appears in the 2-line
front panel and OSD displays. Press the MUTE button again to restore
the volume to its original level. If a front panel Zone 2 input button is
held down, then pressing the MUTE button on the front panel will
mute the Zone 2 output.
On the remote control, pressing the volume button once on the
remote while the volume is muted, turns off mute. Pressing and
holding the Volume button, while the sound is muted, resets to the
original pre-mute volume level, as displayed on the 2-line display,
and then increases or decreases the volume from that point, turning
off mute.
The LED in the MUTE button lights red when the Main Zone mute is
active, green when the Zone 2 mute is active, and amber when
both Zones are muted. The volume can also be muted by using the
MUTE button on the remote control, which functions in the same
manner. However, the remote only mutes Zone 2 if the touch
screen is in the “Zone 2” menu layer.
10 MODE BUTTONS
Use the Mode buttons to scroll to the previous () or next ()
available listening mode. Scrolling the Mode button reveals the
entire list of listening modes available for the currently selected
input and mode family. For more information on selecting listening
modes, refer to Section 3: Setup.
11 ON/STANDBY BUTTON
Toggles the RV-5 between On and Standby. The rear panel Power
Switch must be set to the ON position for the Standby button to be
active. When the RV-5 is in the standby mode, pressing the
Standby button turns the unit on and changes the light in the
Standby button from red to blue. Power is still supplied to the RV-5
when standby mode is activated.
When the rear panel Power Switch is set to the ON position or AC
power is applied or restored, the RV-5 automatically enters the
standby mode.
Note: When taken out of standby, the RV-5 activates the Zone inputs that
were active in the previous operating session.