Filter
Top Products
RV-5 Tuner, PC, & Dock Controls
5-3
Note: The Tuner Input setup displays Digital Audio as NONE, Analog Audio
as TUNER, and the Dig/Anlg Auto parameter is dashed out. These three
parameters cannot be changed for the Tuner Input.
Once the Tuner is activated, the TUNER input button under the
Main Zone heading on the front panel is lit with a blue LED; the
Zone 2 TUNER input button lights with an amber LED. The front
panel of the RV-5 and the 2-line OSD display TUNER and the
current listening mode on the left side of the display; and the
currently selected band frequency, preset location, and volume on
the right side.
TUNER CONTROLS
The front panel controls, the first page of the Tuner remote touch
screen menu, and the third page of the Zone 2 remote touch
screen menu provide identical controls for the AM/FM radio tuner.
AM/FM
Selects the frequency band that the tuner will play. This button
toggles between AM and FM.
ST/MON
Toggles between FM Stereo and Monaural reception. The first press
displays the current state and the second press changes the setting.
Note: This button also controls FM muting of weak signals. In Stereo mode,
very weak signals, or FM static when a signal isn’t present, are muted. In
Monaural mode, no muting is applied, so very weak signals and FM static
are audible.
AUTO/MAN
Controls how scrolling through the frequencies is managed. The
button toggles between Automatic (AUTO) and Manual (MAN)
tuning. The first press displays the current state, “AUTO” or
“MANUAL”, and the second press changes the setting.
AUTO automatically seeks out the next available station when a
TUNE button is pressed; MANUAL only scrolls when the user presses
a TUNE button.
If AUTO is selected, then pressing a TUNE button once will start the
automatic scrolling. Pressing a TUNE button again stops the
scrolling process. If MAN is selected, when either the Tune + or
Tune - button is pressed and held down, the frequencies can be
scrolled through faster.
TUNE +/-
Use the Tune + or Tune - controls to select a frequency. Pressing
either the Tune + or Tune - button enables the user to scroll through
the frequencies. The FM band scrolls in 0.1 MHz increments; the
AM band scrolls in 10 kHz increments. The Auto/Man setting affects
this function.
PRESET +/-
Use the Preset + or Preset - controls to select a previously saved
radio station. Radio stations saved to a preset are displayed to the
left of the associated preset number. There are 30 Presets available
for the Tuner.
To select the preset location of a previously saved radio station,
simply scroll through the Presets until you reach the desired Preset
number. The tuner will automatically switch to play the selected
preset radio station. Holding one of the buttons down scrolls
through the preset locations until the button is no longer being
pressed.
TUNER
LOGIC 7 7CH MU
FM 87.50 01
-32dB