Filter
Top Products
Setup Lexicon
3-18
DEFAULT SUR STANDARD, USE LAST
Identifies the Default Surround Mode that is activated when a digital
source is selected. The STANDARD parameter activates the
“standard” decoder of the source input. The USE LAST selection
allows the RV-5 software to “remember” the last used listening mode
for any given input source. Once selected, that mode will always be
active on the corresponding input until another listening mode is
selected. This parameter affects all inputs.
Note: If the LOGIC 7 DEFAULT parameter in the SURROUND CONFIG
menu is set to ON, the USE LAST selection is defeated and the listening
mode will always switch to a LOGIC 7 mode. For normal functionality
with the USE LAST selection, make sure that the LOGIC 7 DEFAULT
parameter is set to OFF.
A/D SAMPLE RATE 48 KHZ, 96 KHZ
The RV-5 converts the incoming analog audio signals to digital audio
for all audio processing. The A/D SAMPLE RATE parameter allows you
to select the sample rate of the A/D converters. Some surround
processing modes, such as those in the DSP Mode Family, are only
available at the 48 kHz sampling rate. This setting is only available for
incoming analog audio streams and does not apply to any of the
ANALOG BYPASS modes.
A/V SYNC DELAY 0 TO 180 mS
Delays the audio until it matches the on-screen video. Select a value
to activate an audio signal delay to compensate for video that is
delayed relative to the audio. The A/V sync delay range is 0 to 180 ms
in 1 ms increments. Each input has an independent A/V Sync Delay
parameter.
ADVANCED VIDEO
Selects the ADVANCED VIDEO menu, which provides fine-tuning
adjustments to the video output. For more information, refer to the
next section, “Advanced Video”.
Note: Most of the Advanced Video parameters are only available when the
V-Process parameter is set to FAROUDJA.
TRIGGER 2 OFF, ON
Selects the TRIGGER 2 parameter, which configures the Trigger
OUT 2 connector on the rear panel. This trigger output can be
configured independently for each input so that a trigger voltage
signal is sent to the Trigger Out 2 connector when a specific input is
selected. If the Trigger 2 parameter is set to ON, it will output its
voltage when the associated input is activated in the Main Zone. It
is not activated by Zone 2 input switching. The default for the
Trigger 2 parameter is OFF.
ZONE-2 OUT ANALOG, DOWN MIX
Identifies the type of audio that is sent to the Zone 2 outputs. The
ANALOG setting is a straight bypass of the Main Zone stereo analog
audio to the Zone 2 outputs. DOWN MIX provides a stereo DOWN
MIX of the incoming audio to the Zone 2 outputs. DOWN MIX,
which should be selected for digital or multi-channel analog
sources, is only available if the Main Zone has an input selected that
will accept a down mixed source. The ZONE 2 OUT parameter is
NOT input-specific; a selection made for one input will be reflected
in ALL inputs.
INPUT SETUPSETUP
DEFAULT SUR
INPUT SETUPSETUP
A/D SAMPLE RATE
INPUT SETUPSETUP
A/V SYNC DELAY
INPUT SETUPSETUP
ADVANCED VIDEO
INPUT SETUPSETUP
TRIGGER 2
INPUT SETUPSETUP
ZONE-2 OUT