Filter
Top Products
Appendix C Lexicon
C-14
RESTORING FACTORY DEFAULT SETTINGS
If you’re afraid you’ve accidently overwritten functions that you
wanted, or want a “clean-slate” to start from, the remote control can
be reset to its factory default settings. Follow the instructions below to
restore the factory default settings.
Note: Restoring the Factory Default Settings will ERASE all customized
features, including renamed components, learned buttons, and
macros.
1. On the remote control, press and hold the MAIN and STOP
buttons at the same time. The bottom of the touch screen flashes
“WARNING!”.
NOTE: You now have 3 seconds to perform the next step. If a button
is not pressed within 3 seconds, the RESET heading will revert to
MAIN, indicating that the remote control is no longer in Reset mode. If
this occurs, you will need to repeat this step to re-enter the Reset
mode.
2. After about 10 seconds, “RESET” is displayed in the Menu name
section at the top of the LCD touch screen.
A new screen now displays with three options: ALL, PROG, and
EXIT. Touching the EXIT option will leave the menu without
making any changes.
3. Touch the ALL option. The remote will prompt you by displaying
“SURE?”. After the SURE prompt is touched, the factory default
settings are restored.
4. When the remote is done restoring the factory default settings, the
menu heading reverts to MAIN. When the touch screen displays
MAIN in the menu heading area, then the remote control is in
normal operation mode again.
OPTIONAL RF-1 RECEIVER
The optional RF-1 Receiver utilizes the RF feature of the Lexicon remote
control, allowing you to control components that are completely
out-of-sight, up to 100-feet away. Since the RF-1 Receiver picks up the
RV-5’s remote control radio frequency signal, the remote control no
longer needs to be pointed directly at the components to control
them. Now you can close your entertainment center doors, hide your
components, and still control them with ease.
The RF-1 Receiver accessory requires no setup to the Lexicon remote
control in order for the feature to work - you need only place the RF-1
Receiver in the rack or cabinet, or attach an emitter to the RV-5 front
panel over the IR receiver. Every time a command is sent from the
remote control, it sends both a standard IR and an RF signal. The RF-1
Receiver automatically receives the remote’s radio signals and
translates them into the infrared commands that control the
components.
Note: The Lexicon remote control radio signals will not control components
directly. You must have the RF-1 Receiver installed to receive the remote’s
radio signals. Components that came with “no pointing” radio remote
controls cannot be operated by the Lexicon remote unless the component
can be switched to standard IR via its internal menus. Some remote
control ceiling fans are radio only and cannot be operated by the Lexicon
remote.