Appendix A Lexicon
A-2
SPECIFICATIONS
Inputs
HDMI (Version 1.1) 2 HDMI Type A, 19-pin connectors
Analog Video • Three component video, RCA connectors
• Four S-Video connectors
• Four composite video, RCA connectors
Digital Audio • Four S/PDIF coaxial (RCA) and four S/PDIF optical
(Toslink) connectors
• Coaxial & optical input connectors conform to IEC-958,
S/PDIF standards
• One USB mini-B connector
Analog Audio • One 8-channel input array, RCA connectors
• Six Stereo RCA connectors
• One microphone, 3.5mm mono mini plug
• 1 DOCK 30-pin connector (for optional docking station)
• 1 FM antenna
• 1 AM antenna
• Input sensitivity = max input level 2Vrms
Control • One RS-232, 9-pin, D-sub connector
• One IR receiver, on front panel
• One 3.5mm IR IN jack:
Input Voltage: 3V - 15V
Input Current: 10mA
Frequency: 20Hz - 1KHz
Accepts either stereo plug (Tip/Ring/Sleeve) or mono
plug (Tip/Sleeve)
HDMI Performance
HDMI Input Video: 480i/p, 576i/p, 720p, or 1080i
Audio: Dolby Digital, DTS, & PCM (32, 44.1, 48, 88.2, 96 kHz,
176.4 kHz, and 192 kHz)
HDMI Output Video: 480i/p, 576i/p, 720p, or 1080i
Audio: Dolby Digital, DTS, & PCM (32, 44.1, 48, 88.2, 96kHz,
176.4kHz. and 192kHz)
Outputs
HDMI (Version 1.1) One HDMI Type A, 19-pin connector
Analog Video • One component video, RCA connector
• One S-Video connector
• One composite video, RCA connector
Analog Audio • 7-channel amplified, binding posts
• One 8-channel preamplifier plus additional subwoofer,
RCA connectors
• Bare wire: Up to 10 gauge
Control Two triggers - one power on/off & one programmable
3.5mm mono mini plugs
12VDC, 300mA maximum output draw
S-Video& Composite Video Performance
Compatibility NTSC, PAL, and SECAM
A/D converter 12-bit, 110MHz
D/A converter 12-bit, 74.25MHz
Input Level /
Impedance
1V peak-to-peak/75Ω
Output Level /
Impedance
1V peak-to-peak/75Ω
Frequency Response Composite: 10Hz to 8MHz, -3dB
S-Video: 10Hz to 8MHz, -3dB
Component: 10Hz to 100MHz, -3dB
Signal-to-Noise Ratio >65dB
Differential Gain <0.2%
Differential Phase <0.5 degrees
Gain +/- 0.15dB