Filter
Top Products
RV-5 Setup
3-29
5.1-CHANNEL & 7.1-CHANNEL DIRECT INPUTS
There are four listening modes available for use with surround
sources such as DVD-Audio, SACD, HD-DVD, or Blue-ray players.
These listening modes are for use when the RV-5 8-channel direct
inputs are in use. We recommend you use these listening modes
under the following conditions:
• 5.1-CH BYPASS - Use this listening mode when the Rear L/R
inputs are NOT in use and the input source device has its own
internal bass management system. The incoming audio stream
passes from the source directly through to the volume control
without any analog-to-digital conversion. This mode also mutes
the unusued input jacks to prevent unwanted noise from
interfering with system performance.
• 5-CHANNEL - Use this listening mode when the input source
device does NOT have its own internal bass management
system. In this mode, the analog source is converted to digital
so that it uses the same bass management options for the direct
input as used for all other inputs. If all eight channel direct
inputs are in use, then audio from the REAR L/R inputs will be
redirected to the side speakers.
• 7.1-CH BYPASS - Use this listening mode when the 8-channel
direct inputs are in use and the input source device has its own
internal bass management system. The incoming audio stream
passes from the source directly through to the volume control
without any analog-to-digital conversion.
• 7-CHANNEL - Use this listening mode when the 8-channel
direct inputs are in use and the input source device does NOT
have its own internal bass management system. In this mode,
the analog source is converted to digital so that it uses the same
bass management options for the direct input as used for all
other inputs.
DTS & DOLBY STATUS DISPLAYS
The upper right-hand corner of the front panel 2-line display may
indicate status information regarding the incoming source. If a
Dolby or DTS source is input and the RV-5 is configured to a
surround system, the following status indicators may be displayed
to indicate the state of the incoming source:
•ES-ON: Indicates when an encoded DTS signal, discrete or
matrix, is input to the surround back channels. “ON” indicates
that the condition exists, or is active; “OF” indicates that the
condition does not exist, or is off.
• DS-ON: Indicates when the input signal is encoded with Dolby
Surround under the Dolby 2.0 standard. “ON” indicates that
the condition exists, or is active; “OF” indicates that the
condition does not exist, or is off.
•EX-ON: Indicates when Dolby Surround EX is input with the
digital stream, if a surround channel (3/2 or 2/2) exists. “ON”
indicates that the condition exists, or is active; “OF” indicates
that the condition does not exist, or is off.