Filter
Top Products
RV-5 Appendix C
C-9
Favorite Channel Access:
To access the Favorite Channel listings, press the MAIN button to
display page 1 of the Main menu. Touch the FAV (Favorite Channel)
button on the touch screen. A list of favorite TV & cable stations is now
displayed. Each option can be set to instantly select the channel on
your TV. There are five pages of eight favorite channels for a total of
forty buttons.
Favorite Channel Setup:
Before the Favorite Channels can be selected, they must be setup for
your home theater. Follow the instructions to setup your favorite
channel listing.
1. On the remote control, press and hold the MAIN and ENT (Enter)
buttons at the same time. After about 3 seconds, “SETUP” is
displayed in the Menu name area at the top of the LCD touch
screen. This is the Setup mode of the remote control.
NOTE: You now have 30 seconds to perform the next step while the
remote is in the Setup mode. If a button is not pressed within 30
seconds, the SETUP menu name will revert to MAIN, indicating that
the remote control is no longer in Setup mode. If this occurs, you will
need to repeat this step to re-enter the Setup mode.
2. Touch the FAV option to setup your favorite channels. The menu
name changes to “FAV” and the bottom of the screen flashes
“SELECT”.
3. Navigate through the FAV menus until you find the favorite
channel that you want to setup.
Note: You can customize the name of each favorite channel, if
desired. Refer to the “Customizing the Touch Screen” procedure,
found previously in this chapter.
4. Touch the favorite channel that you want to setup. The menu
name will change to display the channel name that was selected.
The bottom of the touch screen displays “STEP 0”, indicating that
you have not yet entered the channel number.
5. Touch the menu option for the component that you will use to
enter the channel number (typically either TV, SAT, or CABLE).
6. Enter the channel number using the number keypad buttons on
the remote.
Note: Some brands of televisions require an ENT (Enter) command
after the channel numbers are entered.
If a number is repeated when setting the channel, for example
channel 522, it is usually best to set a half second delay in
between the identical numbers by pressing the PAUSE (
||)
button. Each press of the PAUSE button increases the delay by
half a second.
7. Press the LIGHT button after you enter the channel number. A new
screen now displays with the options: SAVE, UNDO, and EXIT.
8. To save the channel you just entered, touch the SAVE option. The
UNDO option allows you to erase the last entry. The EXIT option
erases all entries for this channel.
9. To setup additional favorite channels, repeat Steps 3 through 6.
10. When finished, exit the Setup mode by pressing the MAIN button
until the touch screen displays MAIN in the menu heading area.
The remote control is in normal operation mode again.