Filter
Top Products
Setup Lexicon
3-6
REAR AMP REAR AMP, ZONE 2
Selects the REAR AMP parameter, which identifies how the rear
amplifier is utilized. The amplifier can drive the rear speakers in the
Main Zone or the Zone 2 speakers.
To maintain 7.1-channel surround sound in the Main Zone while
using the Zone 2 outputs, the Rear/Zone2 speaker connectors or the
Rear Preamp outputs should be used for the Main Zone rear channels
while the Zone 2 OUT RCA connectors are used with a second
amplifier for the Zone 2 audio.
MANUAL
Opens the MANUAL speaker setup menu, which allows the manual
selection of the speaker distances, cross-over points, and output
levels. See the next section, “Manual Speaker Set-Up”, for more
details.
SEMI AUTOCAL
Selects the SEMI AUTOCAL procedure, which automatically sets the
speaker distances and output levels, as well as performing system
equalization adjustments. The cross-over points for each speaker
must be manually set before this procedure can be run. See the next
section, “Manual Speaker Set-Up”, for more information on how to
set the cross-over points.
Performing the Semi Autocal Procedure:
In order to perform this test, the following initial setup is required:
• All of the speakers are connected to the RV-5 and positioned in
the listening space.
• The cross-over points for each speaker are set through the
MANUAL setup menu. See the following section, “Manual
Speaker Setup”, for information on how to manually set the
cross-over points.
• A monitor is connected to the RV-5 for viewing the OSD during
the procedure.
• The microphone, included with the RV-5, must be connected to
the rear panel Microphone input connector and positioned in
the primary listening position.
For best results, install the microphone onto the accompanying rod by
threading the two parts together and hold or place it in the primary
listening position. Use a microphone stand or tripod if necessary.
The Semi Autocal procedure is performed in the same manner as the
Full Autocal procedure. Refer to the “Performing the Full Autocal
Procedure” for more details.
CAUTION!
DO NOT place the microphone too close to the speakers
during the autocal procedure. If the microphone is within
one foot of the speaker, the test tones that are output
during the autocal procedure could cause a feedback loop
which may damage the speaker. Harman Specialty Group
assumes no responsibility for speaker damage.
SETUP
SPEAKER/EQ SETUP REAR AMP
SETUP
SPEAKER/EQ SETUP MANUAL
SETUP
SPEAKER/EQ SETUP SEMII AUTOCAL