Filter
Top Products
210 Barco - RHDM-2301 - User manual
Addendum
To change the setting of the stand, turn the knob on the right hand side of the stand counter
clockwise to loosen. Choose the new angle and turn the knob clockwise to fix the stand to the new
setting.
WARNING
:
Mind your fingers when tilting the display unit towards negative angles (limited space between control panel and
stand).
7.8.3.3 Control panel
Figure 74: Bottom view of the display unit with mounted control panel
The control panel is mounted at the bottom of the display unit and can be mounted and/or removed
easily.
To remove the control panel from the display unit:
• Place the display unit with the front side on a horizontal, flat and stable table, covered with bub-
ble wrap or a similar protective material.
• Remove the Barco stand (if necessary)
• Unplug the cables that connect the control panel to the display unit.
• Remove the 4 screws that fix the control panel to the bottom of the display unit. Store the
screws at a safe place.
• Mount the Barco stand (if necessary)
To mount the control panel to the display unit:
• Place the display unit with the front side on a horizontal, flat and stable table, covered with bub-
ble wrap or a similar protective material.
• Remove the Barco stand (if necessary)
• Fix the 4 screws to mount the control panel to the bottom of the display unit.
• Connect the necessary cables between the control panel to the display unit.