Filter
Top Products
Barco - RHDM-2301 - User manual 85
Full functionality description
4.2.3 Fault LED
Figure 30: Fault LED
The Fault LED lights up when a hardware failure is detected by the display unit. The Fault LED does
not refer to the display unit operating in non-calibrated mode. When the Fault LED lights up red, the
Cal/Err indicator LED on the bezel will also light up red.
IMPORTANT
:
When an error occurs, consult the OSD submenu “Status controller” to check the warning and/or fault messages.
NOTE
:
When the display unit starts-up from a hard standby status, the Fault LED lights up during the initialization. When
the control panel is fully operational and when the display unit did not detect problems during start-up, the Fault
LED will go out.