Filter
Top Products
Installation Manual for DiBos Video System
A5/11–2004610–4.998.137.176 – 105 –
Configuration (continued)
Configuring an alarm transmission job macro:
No. Name Description
1 New
Creates a new transmission job macro.
Click on New and enter the name in the input box.
2 Delete
Deletes an existing transmission job macro.
Select a transmission job macro in the list box and
click on Delete. The transmission job macro will be
deleted.
3 Copy Copies an existing transmission job macro.
Select a transmission job macro in the list box and
click on Copy. The transmission job macro is copied
and can be adapted quickly.
4 Remote stations
Available stations This list box contains all remote stations known in the
system.
Stations to be
called
This list box contains the stations that should be
called by this job macro. The job macro should create
a connection to these stations.
During selection, proceed as follows:
Select the station and possible spare stations, to
which a connection should be established, from the
list box of available stations and click the <<button.
The selected stations are added to the list box of
stations that are to be called.
Note:
Please note that the system processes the stations
that are to be called from top to bottom if no
connection can be established with the top station.
This means that the remote station at the top must
be the station that you wish to communicate with first.
The other stations are spare stations.
5 Hold connection as
long as input status
unchanged
Activate this function when the connection should
only exist as long as the input status is unchanged. If
the input status changes and the function is
activated, the connection will be disconnected.
6 Timeout for
connection setup
Enter the time within which an attempt should be
made to establish a connection to the relevant
station.
Note:
If the total time of the connection setup to a remote
station has elapsed (and the triggering criteria still
exists and item 5 is selected), an attempt to set up a
connection to the next station in the list is started
automatically, using the same settings.