Filter
Top Products
Installation Manual for DiBos Video System
A5/11–2004610–4.998.137.176 – 5 –
Safety instructions (continued)
For Indoor Product
1.
Water and Moisture – Do not use this unit near water – for example, in a wet basement, in
an unprotected outdoor installation, or in any area classified as a wet location.
2. Object and Liquid Entry – Never push objects of any kind into this unit through openings, as
they may touch dangerous voltage points or short out parts that could result in a fire or electrical
shock. Never spill liquid of any kind on the unit.
3. Power Cord and Power Cord Protection – For units intended to operate with 230VAC, 50Hz,
the input and output power cord must comply with the latest versions of IEC Publication 227
or IEC Publication 245.
Power supply cords should be routed so they are not likely to be walked on or pinched. Pay
particular attention to location of cords and plugs, convenience receptacles, and the point of
exit from the appliance.
4. Overloading – Do not overload outlets and extension cords; this can result in a risk of fire or
electrical shock.
For Rack–Mount Product
1. Ventilation – This unit should not be placed in a built–in installation or rack, unless proper ven-
tilation is provided, or the manufacturer’s instructions have been adhered to. The equipment
must not exceed its maximum operating temperature requirements.
2. Mechanical Loading – Mounting of the equipment in a rack shall be such that a hazardous
condition is not achieved due to uneven mechanical loading.
WARNING: Electrostatic–sensitive device. Use proper CMOS/MOS-
FET handling precautions to avoid electrostatic discharge.
NOTE: Grounded wrist straps must be worn and proper ESD safety pre-
cautions observed when handling the electrostatic–sensitive printed cir-
cuit boards.
CAUTION: Lithium Battery
Danger of explosion if battery is incorrect replaced. Replace only with the same
or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the battery manufacturer’s instructions.
Cover Removal
WARNING: Removal of the cover should only be performed by qualified service
personnel – not user serviceable. The unit should always be unplugged before re-
moving the cover and remain unplugged while the is removed.