Filter
Top Products
Installation Manual for DiBos Video System
A5/11–2004610–4.998.137.176 – 32 –
Connections (continued)
4.9 Connecting the Software Dongle and
the Printer
The programs are protected against unauthorized use by a dongle. The
system cannot be operated without this dongle. The dongle must be con-
nected to the PRN interface (LPT1) on the system board and remains
there throughout operation. The dongle must be plugged in before
switching the system on.
A printer must be connected via the USB interface so as not to hinder the
reading out of program information from the dongle.
4.10 Connecting a Fault Indicator
A fault indicator (sounder) can be connected to relay 4 of the 1st MVTitan
grabber card (must be activated in the configuration under Hardware/
Connections).
The following events will be signaled by the fault indicator:
D Images may be lost because the alarm archive is full
D The free disk space is not sufficient for the programmed total size of
the archives
D The camera is not transmitting a video signal
D The database server could not record all images
D The grabber process does not answer in the prescribed time (timeout)
D The programmed holidays/special days are not released in the hard-
lock
D The programming for the serially–connected security system has
been deleted by a software update
D System overload
D The directory could not be deleted from the database server
D Cannot create and write logbook
D The images could not be recorded by the database server
D The backup medium is full
D A timed backup could not be executed because a search macro was
not found
D The programmed number of grabbers does not match the actual
hardware configuration
D 5% of the hard disk is not free
D The database server is not started