Filter
Top Products
Installation Manual for DiBos Video System
A5/11–2004610–4.998.137.176 – 36 –
Connections (continued)
4.12 Connecting the Barcode Reader
4.12.1 Barcode Reader V3300–N
Only the barcode readers listed below should be used. With other types
of barcode readers, you must check whether their protocol matches that
of the video system.
COM x
video system
V3300–N
Barcode
scanner
Connection cable
9–pin – 25–pin
COM1
COM2
COM3
Note:
Two OVS are required for distances > 20 m.
(See Connecting the ATM, Method 2)
COM1/2/3
To operate the VS3300–N, you must change some settings. A preconfi-
gured hyperterminal program, which can be called up from the diskette
under Windows r XP by typing in ”VISOLUX SCANNER.ht,“ is used as
the program editor for the V3300–N.
Programming the V3300–N
The V3300–N can only be programmed on its internal COM2 or COM3
interface; this must be done before calling up the video system program.
Connect the V3300–N to the COM2 interface of the video system as fol-
lows.
COM2
video system
V3300–N
Connection cable
9–pin – 25–pin
COM2/3
Hyper terminal
Certain settings are necessary on the V3300–N itself in order to program
it. The following list gives you a brief summary. For more details, please
refer to the listed sections of the V3300–N manual.
D Activating programming mode
→ see ”Setup Mode” Section
D Setting the baud rate, number of data bits, number of stop bits, and
parity
→ see ”Changing Baud Rate”, ”Changing Number of Data Bits”,
”Changing Stop Bits” and ”Changing Parity” Sections