Filter
Top Products
Installation Manual for DiBos Video System
A5/11–2004610–4.998.137.176 – 4 –
Safety instructions (continued)
12. Grounding or Polarization – This unit may be equipped with a polarized alternating current line
plug (a plug with one blade wider than the other). This safety feature allows the plug to fit into the
power outlet in only one way. If unable to insert the plug fully into the outlet, try reversing the plug.
If the plug still fails to fit, contact an electrician to arrange replacement of the obsolete outlet. Do
not defeat the safety purpose of the polarized plug.
Alternately, this unit may be equipped with a 3–wire grounding plug (a plug with a third pin, for
grounding). This safety feature allows the plug to fit into a grounding power outlet only. If unable to
insert the plug into the outlet, contact an electrician to arrange replacement of the obsolete outlet.
Do not defeat the safety purpose of the grounding plug.
13. Lightning – For added protection during a lightning storm, or when this unit is left unattended
and unused for long periods of time, unplug the unit from the wall outlet and disconnect the cable
system. This will prevent damage to the unit due to lightning and power line surges.
14. Restricted Access Locations are required for the installation.
FCC & ICES Information
(U.S.A. and Canadian Models Only)
This device complies with part 15 of the FCC Rules. Operation issubject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC Rules and ICES–003 of Industry Canada. These limits are de-
signed to provide reasonable protection against harmful interference when the equipment is oper-
ated in a residential installation. This equipment generates, uses and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
D Reorient or relocate the receiving antenna.
D Increase the separation between the equipment and receiver.
D Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
D Consult the dealer, or an experienced radio/TV technician for help.
Intentional or unintentional changes or modifications, not expressly approved by the party responsi-
ble for compliance, shall not be made. Any such changes or modifications could void the user’s au-
thority to operate the equipment.
The user may find the following booklet, prepared by the Federal Communications Commission,
helpful: How to Identify and Resolve Radio–TV Interference Problems. This booklet is available from
the U.S. Government Printing Office, Washington, DC 20402, Stock No. 004–000–00345–4.