Filter
Top Products
Installation Manual for DiBos Video System
A5/11–2004610–4.998.137.176 – 35 –
Connections (continued)
D Method 3:
Problem:
The automatic teller machines (ATMs) are located further away from the video
system. The distance between the video system and interface processor and be-
tween the interface processor and an ATM cannot be less than 15 m.
However, the ATMs are not close enough to one another for them all to be con-
nected to the interface processor so that the distance between the interface proc-
essor and each ATM is less than 15 m.
Solution:
The interface processor is connected directly to the video system.
To increase the range, two OVS units are required between the interface
processor and each ATM.
Connection
principle:
Detailed connection:
9–pin connection cable
Order no. 4.998.079.686
(connection 1:1)
ATM1
ATM–specific cable
connection or adapter
OVS 1
V24
(C3)
OPTO
1
5
9
6
OVS 2
OPTO
9
6
1
5
9 pin 9 pin
Range
max. 1000 m
For jumpering,
see below
1
2
3
1
2
3
C3:
Pin 2 = transmitter line
Pin 3 = receiver line
J2 J1
Jumpering of OVS 1:
For jumpering,
see below
For assignment of OVS see Section 4.18.1
V24
(C3)
Interface
processor
Connection cable
to the video system
(COM x)
To ATM4
(or AC system)
To ATM3
To ATM2
Like ATM1
Like ATM1
Like ATM1
OVS
Interface
processor
OVS ATM4
ATM1
OVS OVS
max.
max. max.max.
15 m
15 m 15 m1000 m
video system
Jumpering of OVS 2:
Corresponding ATM
I4I3 PCI2I1
Note:
By changing jumper J1 and J2 in the OVS it is possible to mix up the transmitter and receiver
lines.