Filter
Top Products
Installation Manual for DiBos Video System
A5/11–2004610–4.998.137.176 – 38 –
Connections (continued)
4.13 Connecting Foyer Card Reader MINITER RS 485
The foyer card reader MINITER RS 485 is connected via a serial inter-
face. A maximum of four foyer card readers can be connected in series.
The foyer card reader LS23M and the foyer card reader MINITER RS 485
can be operated on the same serial bus. Please note that the foyer card
reader LS23M should preferably be installed as the last bus element.
COM x
video system Interface converter
W&T 86000
4.998.053.926
10
Connection cable
9–pin – 25–pin
22
11
23
19
21
13
25
14
RS232
5 V DC
4.998.098.769/
4.998.098.767
Foyer card reader 1
(MINITER RS 485)
Foyer card
reader 4
(LS23M)
2 x 0.6 mm per wire
J2
inserted
4
5
4
5
Note:
D The distance between the interface converter and the last foyer card reader
must not exceed 1000 m (installation cable J–Y(St) Y 2 x 2 x 0,6 mm).
D Ensure the foyer card reader is correctly grounded.
D Shielding may only be applied on one side.
D The foyer card readers must only be connected
via the card reader connectors.
D If the last foyer card reader on the RS 485 bus is a MINITER,
then for termination of the RS 485 bus, a terminal resistance of
250 ohms is always required (resistance is included in the scope
of delivery)
D To enable the foyer card reader to read the cards, the back square
at the rear of the inner housing must be cut out.
MINITER RS 485 contact assignment
For additional information about interface converter functions,
please refer to the description for the W&T Interface Model 86000.
M door opener Output (PIN 2)
RK/AK door opener Output (PIN 3)
Signal RS 485– (PIN 4)
Signal RS 485+ (PIN 5)
+ 12 V DC Input (PIN 6)
Fuse
Tamper switch
0 V DC Input, GND (PIN 1)