Filter
Top Products
Remove and Replace
6-32
WFM90D and WFM91D Service Manual
Replace. To replace the battery power connector:
1. Solder the battery power connector wires to the battery contacts. See
Figure 6--16.
2. Install the bottom cover. Refer to Bottom Cover on page 6--31.
Remove. To remove the battery contacts:
1. Remove the bottom cover. Refer to Bottom C over on page 6--31.
2. To remove one of the battery contacts that has the battery power connector
soldered to it, unsolder the battery connector wire before you remove the
battery contact.
3. Pry the battery contact past the retaining lip on the bottom cover. See
Figure 6--15.
Alignment ridge
Retaining lip
Battery contacts
Figure 6- 15: Battery contact installation alignment
4. Push the battery contact through the slot on the bottom cover.
Battery Contacts