Filter
Top Products
Using the Menus
WFM90D and WFM91D Service Manual
2-19
Press the AUDIO button and the MENU button to open the Audio operating
menu. There is no digital menu for audio. For more details on menu access, see
page 2--17.
Audio menu choices are shown in Table 2--3. The Audio menu tree is shown in
Figure 2--10.
Table 2- 4: Audio menu choices
Submenu Function
REFERENCE
dBu
Sets the Audio reference level to MIC, --10, 0, 4, or 8. The reference levels
are measured in dBu, and the MIC level is for testing microphones.
HEADROOM Sets the headroom reference level to --3 dB or +10 dB. Use the +10 dB
setting for viewing signal levels greater than 3 dB over the reference level.
Press the PIX button and the MENU button to open the Picture operating menu.
Hold the MENU button in for two seconds to open the digital menu. For more
details on menu access, se e page 2--17.
Picture menu choices are shown in Table 2--5. The Picture menu tree is shown in
Figure 2--10.
Table 2- 5: Picture menu choices, analog and digital
Submenu Digital only Function
ACTION WFM90D only. Turns the Safe Action area markers on
and off.
TITLE WFM90D only. Turns the Safe Title area markers on and
off.
SAFE AREA WFM91D only. Turns the Safe Area markers on and off.
VSHIFT Turns the vertical shift on and off. The vertical shift allows
you to view the vertical interval on the Picture display.
The vertical interval display does not appear on the
VIDEO OUT signal.
EDH RPRT n Enable or dis able the EDH reporting readout at the top
center of the display in Waveform and Vector modes.
CRC WTCH n CRC Watch. Enable or disable the CRC reporting
readout on the right side of the display in Waveform and
Vector modes.
Audio Menu
Picture Menu