Filter
Top Products
*LRN?
*LRN? returns a sequence of commands that may be resent to the Agilent E1446A
to return it to its current programming state.
Note *LRN? should be sent singly in a program message, since the number of commands
in the returned sequence is large, and may vary depending on firmware revision.
Comments • Executable when initiated: Yes
• Coupling group: none
• Related commands: *RCL, *RST, *SAV
• *RST Condition: none
*OPC
*OPC causes the E1446A to wait for all pending commands to complete. The
Operation Complete bit (bit 0) in the Standard Event Status Register is then set.
Comments
• Executable when initiated: Yes
• Coupling group: none
• Related commands: *OPC?, *WAI
• *RST Condition: none
*OPC?
*OPC? causes the E1446A to wait for all pending commands to complete. A single
ASCII “1" is then placed in the output queue.
Comments
• Executable when initiated: Yes
• Coupling group: none
• Related commands: *OPC, *WAI
• *RST Condition: none
*LRN?
3-30 Command Reference IEEE-488.2 Common Commands