Filter
Top Products
[:STATe]
OUTPut1[:STATe] <mode> closes or opens the output relay of the “Main Output”
BNC to enable or disable the analog output. When disabled, the output appears as
an open circuit.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
mode boolean OFF|0|ON|1 none
Comments
• Coupling group: none
• *RST Condition: OUTPut1:STATe ON
• The output relay will be opened automatically if an output current overload occurs.
Example Disabling the output
OUTP1 OFF Disable output
[:STATe]:ACTual?
OUTPut1[:STATe]:ACTual? determines if the amplifier’s ’Main Output’ BNC is
enabled or has been disabled due to an overload condition. The determination is
done by reading bit 8 of the amplifier’s Status register (Appendix C).
Comments
• A one (1) returned in response to the query indicates the ’Main Output’ BNC is
enabled. A zero (0) indicates the output is disabled.
• Coupling group: none
• *RST Condition: none
Example Determining if the output is enabled
OUTP1:STAT:ACT? determine if the output is enabled
OUTPut1 [:STATe]
3-14 E1446/E1405/06 Command Reference OUTPut1 Subsystem