Filter
Top Products
180 ! Look for illegal values and settings conflicts
190 !
200 IF In1_atten< 0 OR In1_atten> = 31.5 THEN
210 DISP "Invalid INP1:ATT value"
220 STOP
230 END IF
240 IF In1_imped< > 50. AND In1_imped< > 75. AND In1_imped< > 1.E+ 6 THEN
250 DISP "Invalid INP1:IMP value"
260 STOP
270 END IF
280 !
290 IF In2_atten< 0 OR In2_atten> = 31.5 THEN
300 DISP "Invalid INP2:ATT value"
310 STOP
320 END IF
330 IF In2_imped< > 50. AND In2_imped< > 75. AND In2_imped< > 1.E+ 6 THEN
340 DISP "Invalid INP2:IMP value"
350 STOP
360 END IF
370 !
380 IF Out1_atten< > 0. AND Out1_atten< > 20. THEN
390 DISP "Invalid OUTP1:ATT value"
400 STOP
410 END IF
420 IF Out1_imped< > 0. AND Out1_imped< > 50. AND Out1_imped< > 75. THEN
430 DISP "Invalid OUTP1:IMP value"
440 STOP
450 END IF
460 IF Out1_imped= 0 AND Out1_atten= 20 THEN
470 DISP "OUTP1:ATT 20 not allowed with OUTP1:IMP 0"
480 STOP
490 END IF
500 !
510 IF Out2_imped< > 50. AND Out2_imped< > 75. THEN
520 DISP "Invalid OUTP2:IMP value"
530 STOP
540 END IF
550 !
560 IF Out3_imped< > 50. AND Out3_imped< > 75. THEN
570 DISP "Invalid OUTP2:IMP value"
580 STOP
590 END IF
600 !
610 Out_imped= Out1_imped
620 Set_e46_offset(Offset)
630 !
Continued on Next Page
Example Programs Register-Based Programming C-27