Filter
Top Products
Example Programs
The program listings in this section are BASIC programs in
LOAD/STORE format and are contained on the example programs disk
Agilent P/N E1446-10031. GET/SAVE versions of these programs are
on example programs disk Agilent P/N E1446-10032.
The examples in this section include:
• Amplifying a Sine Wave
• Setting the (amplifier) Input Impedance
• Setting a DC Voltage Offset
• Using the Differential (small signal) Outputs
• Summing Two Signals
The programs in this section are the same as those in Chapter 2.
However, the amplifer is programmed at the register level using the
flowchart of Figure C-4 . Note also that the amplifier is in the servant
area of the E1480A V/360 controller, and not in the servant area of the
E1445A (see below).
System
Configuration
The register-based programs in this section were developed using the
following system configuration:
Controller: Agilent E1480A V/360 Embedded Controller
(select code 16)
Mainframe: Agilent 75000 Series C
Slot 0/Resource Manager: Agilent E1480A V/360
E1446A Logical Address: 88
E1445A Logical Address: 80
E1445A Servant Area: 0
Communication between the controller and E1445A/E1446A is through
paths 1 and 4 mentioned under "Using an Embedded Controller" in
Chapter 1.
Example Programs Register-Based Programming C-17