Filter
Top Products
SOURce2:VOLTage
The SOURce2:VOLTage subsystem controls the output offset voltage at the Agilent
E1446A’s “Main Output” BNC.
Subsystem Syntax SOURce2
:VOLTage
[:LEVel]
[:IMMediate]
:OFFSet <voltage>
[:LEVel][:IMMediate]:OFFSet
SOURce2:VOLTage[:LEVel][:IMMediate]:OFFSet <voltage> sets the offset
voltage at the “Main Output” BNC. Output offset level is programmed in volts.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
number numeric -9.999695 to +10.0|
MINimum|MAXimum
volts
MINimum selects -9.999695; MAXimum selects +10.0.
The above limits are doubled if OUTPut2:IMPedance 0 is set.
The combination of input levels and offset voltage must produce a voltage that
remains within the Agilent E1446A’s output voltage specification. Significant
distortion of the waveform will occur when the combination of input levels and
offset voltage exceeds the specification.
Example Setting offset voltage
Comments
• Executable when initiated: Yes
• Coupling group: Power amplifier
• Related commands: OUTPut2:IMPedance
• *RST Condition: SOURce2:VOLTage:LEVel:IMMediate:OFFSet 0 V
Example Setting offset voltage
SOUR2:VOLT:OFFS 3 Set offset voltage to 3 volts
SOURce2:VOLTage Subsystem E1446/E1445 Command Reference 3-17