Filter
Top Products
*PMC
*PMC purges all macro definitions.
Comments
• Use the *RMC command to purge an single macro definition.
• Executable when initiated: Yes
• Coupling group: none
• Related commands: *DMC, *RMC
• *RST Condition: none
*RCL
*RCL <number> restores a previously stored programming state from one of the 10
possible stored state areas. Number indicates which of the stored state areas should
be used.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
number numeric 0 through 9 none
Comments
• Executable when initiated: No
• Coupling group: none
• Related Commands: *LRN?, *RST, *SAV
• *RST Condition: unaffected
• Power-on Condition: all saved states set to the same state as the *RST state
*RMC
*RMC <name> purges only the specified macro definition.
NOTE: At printing time, *RMC is a command proposed and accepted for a revision
and re-designation of IEEE-488.2.
Comments
• Use the *PMC command to purge all macro definitions in one command.
• Executable when initiated: Yes
• Coupling group: none
*PMC
IEEE-488.2 Common Commands Command Reference 3-31