ATM-BCH (ATM B-Channel Trunk)
Issue 1 June 2005 515
Table 162: Test #256 Service State Audit Test
Error
Code
Test
Result
Description / Recommendation
1000 ABRT Needed resources not available, port on a call or initializing
1. Run status trunk grp#/mem#.
2. Check the results of Test #255.
1018 ABRT Maintenance disabled
1. Enable maintenance by entering y in the Maintenance Tests field on
the change trunk-group screen.
1113 ABRT Signaling link failed
1. Run status trunk grp#/mem#.
2. Check the results of Test #255.
3. See ATM-SGRP (ATM Signaling Group)
on page 598.
1114 ABRT Signaling link in transitional state
1. Retry the command up to 5 times at 1-minute intervals.
1116 ABRT Trunk not in Out-of-Service/Far-end state and country protocol other than 1
1117 ABRT Service-state audit message outstanding
1. Wait 2 minutes, then try again.
2100 ABRT Could not allocate needed resources
1. Retry the command up to 5 times at 1-minute intervals.
1113 FAIL Signaling link failed
1. See ATM-SGRP (ATM Signaling Group)
on page 598 and ISDN-PLK
(ISDN-PRI Signaling Link Port) on page 1423.
FAIL Internal system error
1. Retry the command up to 5 times at 1-minute intervals.
PASS PASS
1. Wait 4 minutes, then check the Error Log for any new Error Type 3073.
● If there are none, both sides of the ISDN connection agree on the
service state. The negotiation succeeded.
● If there is a new 3073 error, then the negotiation failed (the request
timed out).
