Filter
Top Products
Print Data *Manual Number Revision
Jan., 2002 SH(NA)030012-B Section 12.2.6 (2) (b): Diode mounting diagram modification
Section 12.2.7 (1): Our leakage current breaker product model name changing
Addition of MR-J2M-70DU to Table 12.4
Section 12.2.8 (2): Addition of the case with 1-phase 200 to 230VAC power
supply
Section 13.2 (1): Reexamination of table
Sept., 2002 SH(NA)030012-C Safety Instructions: Addition of About wiring protection
Addition of EEP-ROM life
Section 1.5 (2) (a): Change of rating plate
Section 2.4 (2): Reexamination of description
Section 2.6 (1) (d): Reexamination of sentence
Section 3.4.2: Addition of cable side connector 353717-2
Addition of Note
Section 3.5.1: Addition of POINT
Section 3.6: Addition of Note to timing chart
Section 5.1.2 (2): Addition of DRU parameter No. 23 encoder cable selection
Section 5.2.2 (1): Addition of IFU parameter No. 9 SSCNET type selection
Section 5.2.2 (2): Addition of IFU parameter No. 9 SSCNET type selection
Section 6.2.2: Addition of POINT
Section 9.1: Addition of A. 78 and A. 79
Section 9.2: Addition of A. 78 and A. 79
Section 10.3 (3): Addition of contact 353717-2
Addition of applicable tool 937315-1
Section 11.1: Layout change
Addition of Note
Section 12.1.1 (1): Addition of sentence
Deletion of Note
Section 12.1.1 (4): Addition of terminal block, terminal screw and tightening
torque
Section 12.1.2 (1): Addition of encoder cable MR-JC4CBL
M-H
Section 12.1.2 (2) (a): Addition of POINT
Section 12.1.2 (2) (b): Addition
Section 12.1.3 (1): Change of Usage and Connection diagram
Section 12.1.4 (2): Reexamination of display description and representation
Section 12.2.1 (2): Addition of encoder cable MR-JC4CBL
M-H
Section 13.3: Change of representation
Apr., 2003 SH(NA)030012-D CONFORMANCE WITH UL/C-UL STANDARD (2) Installation: Addition of air
volume 2.8m3/min
Section 1.3 (1): Addition of inrush current
Section 3.1: Partial reexamination of connection diagram
Reexamination of motion controller-compatible bus cable in Note
13
Section 3.4: Partial change of CAUTION sentence
Section 3.4.4 (3): Partial reexamination of connection diagram
Section 3.5.3 (2): Reexamination of diagram
Section 4.2.4 (2): Partial reexamination of sentence
Section 5.1.2 (2): Addition of "When built-in regenerative brake resistor is used"
to DRU parameter No. 2