Filter
Top Products
2 - 4
2. INSTALLATION AND START UP
2.5 Mounting method
(1) Base unit
As shown below, mount the base unit on the wall of a control box or like with M5 screws.
Wall
(2) Interface unit/drive unit (MR-J2M-40DU or less)
The following example gives installation of the drive unit to the base unit. The same also applies to the
interface unit.
Sectional view
Drive unit
Base unit
Wall
Catch
Positioning hole
1)
1) Hook the catch of the drive unit in the positioning hole of the base unit.
Sectional view
2)
Drive unit
Base unit
Wall
2) Using the catch hooked in the positioning hole as a support, push the drive unit in.