Filter
Top Products
4 - 9
4. OPERATION
(2) Indication list
Indication Status Description
d ##
Ready
The servo was switched on after completion of initialization and the servo amplifier is ready
to operate. (This is indicated for 2 seconds.)
C # #
Not ready The servo amplifier is being initialized or an alarm has occurred.
(Note 1)
$ $ $
Ready for operation
Two seconds have passed after the servo amplifier is ready to operate by turning ON the
servo-on (SON).
(Note 2)
A
Alarm Warning The alarm No./warning No. that occurred is displayed. (Refer to section 10.2.)
8 88
CPU error CPU watchdog error has occurred.
(Note 3)
0 0.b
(Note 3)
Test operation mode
JOG operation
positioning operation programmed operation DO forced output single-
step feed
# #.d
Motor-less operation
# #.C
Note 1. $$$ indicates numbers from 0 to 255, and the number indicates the executing point table number.
2.
indicates the warning/alarm No.
3. Requires MR Configurator or MR-PRU03 parameter module.