Filter
Top Products
6 - 3
6. MR Configurator
(b) Connection with servo amplifier
1) For use of USB
MR-J3- T MR-J3-D01
CN5
USB cable
MR-J3USBCBL3M
(Option)
Personal computer
To USB
connector
2) For use of RS-422
MR-J3- T MR-J3-D01
CN3
RS-422/232C
conversion cable
DSV-CABV
(Diatrend)
Personal computer
To RS-232C
connector
(Note)
Note. Do not connect to the CN30 connector of MR-J3-D01. It cannot be used if connected.
3) For use of RS-422 to make multidrop connection
MR-J3- T MR-J3-D01
CN3
MR-J3- T MR-J3-D01
CN3
MR-J3- T MR-J3-D01
CN3
(Note 3)
(Note 2)
(Note 2)
(Note 2)
(Note 4)
(Note 4)
(Note 4)
(Note 1)
To RS-232C
connector
Personal computer
RS-422/232C
conversion cable
DSV-CABV
(Diatrend)
Note 1. Refer to section 13.1 for cable wiring.
2. The BMJ-8 (Hakko Electric Machine Works) is recommended as the branch connector.
3. The final axis must be terminated between RDP (pin No. 3) and RDN (pin No.6) on the receiving side (servo amplifier) with
a 150
resistor.
4. Do not connect to the CN30 connector of MR-J3-D01. It cannot be used if connected.