Filter
Top Products
1 - 29
1. FUNCTIONS AND CONFIGURATION
(3) For MR-J3-11KT(4) to MR-J3-22KT(4)
CAUTION
Avoid touching any remained burr after cutting off the part a) of the case. Any
injuries may be caused.
The installing screws for the MR-J3-11KT(4) or more are covered at shipping. When installing the MR-J3-D01
for the first time, cut off the part a) of the case after removing the side cover. When cutting off the part a) , avoid
damaging the case of the servo amplifier. After cutting off it, inside of the servo amplifier has been exposed
even though the side cover and the MR-J3-D01 are installed. Avoid entering unwanted parts inside of the servo
amplifier from the opened area. Refer to section 3.2 (2) in this section for installing and removing the MR-J3-
D01. The side cover for the MR-J3-11KT(4) or more is the same construction as the MR-J3-D01. Install and
remove the side cover in the same procedure as the MR-J3-D01. However, the installing screw for the side
cover is unnecessary.
a)